Today's card is triple stamping but it's inverted. I don't know where I saw it, so I apologise to whoever had the idea!
Card Measurements
Card base: 29.7cm x 10.5cm scored at 14.9cm and folded
Front layers: 14.5cm x 10cm (x2)
Inner layer: 14.5cm x 10cm
Instructions
- You will need 5 layering dies and 2 colours of cardstock.
- On your lightest coloured cardstock (or DSP) stamp your image/s
- Starting with the largest of your layering dies (#1), die cut (at same time) #1, #3 & #5 from stamped cardstock
- On your darker colour cardstock die cut #2 and #4 (at the same time)
- Always making sure your stamped cardstock is matching the images, adhere #2 die cut to the back of #1 (main piece) using glue
- Then adhere #4 to #3 and left over middle of dark cardstock to #5, using glue
- Add dimensionals to the back of #1/2, #3/4 and #5/leftover middle (Add them as close as you can to the cut out centre)
- Placing #5/leftover middle on table, line up #3/4 on top of it and adhere, then line up #1/2 on top of #3/4 and adhere
- Adhere dimensionals to outside corners of #1/2 in a stack 3 deep and adhere to front of card base
I hope you enjoyed this project.
Cheers
Deb xx
No comments:
Post a Comment
Thank you for taking the time to leave a comment on my blog, it is most appreciated!