Inkstability: Pansy Patch Angled Slide Lock

It's time to hop again with:

This month the theme is: All Things Floral

I've absolutely fallen in love with another stamp set! Pansy Patch!!! Such an amazingly beautiful suite!

My card today was inspired by Erica Edney and her video.

Card Measurements

Card base: 27.5cm x 14.9cm scored at 10.4cm and 21cm

1st layer: 14.5cm x 10cm (left flap)

2nd layer: 14.5cm x 6cm (right flap)

Inner layer: 14.5cm x 10cm

Extra card stock for flowers, leaves and ovals

Instructions

Make a mark at 23.5cm and cut from mark to bottom right hand corner of card base
Make a mark on 2nd layer at 2cm (short side) and cut from mark to bottom left hand corner
Line up the classic punch as high as it will go and about 1.5cm from from edge of large flap and punch
Fold smaller flap under large flap and mark inside right hand side of punch
Line up punch with mark on smaller flap and punch
Adhere 1st layer to large flap of card front
Adhere 2nd layer to smaller flap of card front
Line up punch with previously punched slot and punch 1st layer
Line up punch with previously punched slot and punch 2nd layer
Cut a scalloped oval big enough to cover slot from extra card stock
Cut an oval from extra card stock for inside of card front
Place plain oval under slot from large flap
Adhere a dimensional to oval through slot making sure straight sides of dimensional are parallel to straight edges of slot so it will slide easily
Line up scalloped oval so there is enough clearance for smaller flap to open and adhere to dimensional of plain oval
Stamp flowers and leaves
Die cut flowers and leaves
Adhere two leaves to left hand side of each large flower
Adhere three large flowers (two using dimensionals) to scalloped oval (make sure they don't overhang on right hand side)
Adhere small flowers to long stems
Adhere small flowers to front of large flap above slot
Stamp sentiment on front of large flap
Adhere inner layer to inside back of card base
Adhere flower and leaves to bottom corner of inner layer